Adds static entries to the MAC address table or configures a static MAC address with IGMP snooping disabled for that address. show mac address-table aging-time Displays information about the time-out values for the MAC address table.
address EEEE.EEEE.EEEE (Optional) Displays a count of the MAC address table entries for a specific address. dynamic (Optional) Displays a count of the dynamic MAC addresses. static (Optional) Displays a count of the static MAC addresses. interface (Optional) Specifies the interface. The interface can be Ethernet or EtherChannel. ethernet slot/port
Aug 16, 2012 · I have the Wendell Odom study books for INCD1 & 2, and have seen the show mac address table command in two formats. show mac-address-table & show mac address-table . I also have the Cisco Press CCNA Flashcards book also, and that only mentions the first command above.
|How to see mac address of the switch that you are||Oct 30, 2018|
|Show mac address of device connected to switch without ip||Jan 30, 2018|
|Mac address table – 77078||Nov 07, 2014|
|«show arp» and «show mac address-table» – 70446 – The||May 08, 2014|
The switch then displays the MAC address table for that VLAN (Example of the address table.) Example of the address table To page through the listing, use N ext page and P rev page .
Hi All, When I type sw1#show mac address-table interface fastEthernet 1/2 command, I get this output: sw1#show mac address-table interface fastEthernet 1/2
Switches maintain a database of MAC addresses, both manually configured (static) and dynamically learned entries. During troubleshooting, it may be helpful to investigate the entries in the MAC table. To view the whole MAC table, use the following command from enable mode: show mac-address-table
show mac address-table or show port address But the IP address I have written down is not correct. I have a core switch a HP 5412 this switch is connected to the core switch.
The MAC address table is the result of layer 2 activity and is built as layer 2 interfaces receive a frame and discover the source MAC address of the frame. So the MAC address table is the result of switching activity and the ARP table is the result of routing activity.
Aug 04, 2015 · What is the difference between «show mac-address-table» and «show int mac-address» New to Cisco networking and trying to get my head round this one?
We can find mac address (physical address) of a computer using the command ‘getmac‘.This can be used to get mac address for remote computers also. Below are few examples on …
show mac-address-table address. Displays a specific address. Syntax. show mac-address-table address Default. None. Command mode. Privileged EXEC. Command parameters
One such command to show a list of MAC addresses of ports is the «Show mac address-table» command. Showing a List of MAC Addresses on Ports. Connect the console cable to the CON port of the switch. Connect the other end to the COM port of the computer.